All painters will tell you: there is no beautiful painting without careful preparation of the background. The same is when you paint your house walls with colors to make the interior look more appealing.
If you do not focus on making the surface strong, it will affect the paint’s longevity. Moreover, you will have to rework sooner than necessary to stand up to the environmental hazards.
Therefore, as the experts at Attention to Detail Painters say, surface preparation should be the first step in the wall painting process, especially for people living in Littleton, CO, where the harsh winter tends to damage the wall and ceiling paints more than any other state. Click here to get professional painting assistance today!
However, this step may add a few more days to your painting schedule, but the paint longevity it offers is going to be worth everything.
Consider the following pointers to understand how surface preparations optimize paint duration over time. Moreover, you can also prepare your wall surfaces with the below-mentioned tips and tricks!
· Helps In Filling a Crack
Small cracks and holes left by blows or old bores can be easily identified in the surface preparation process. Here, you can fill any crack in the wall with a simple filling before putting the coating on it.
For this, you need to slightly open the crack with a triangular scraper, remove the dust, and apply the product (filling) in small strokes. Ensure using calico in the repair, which will be placed on the fresh paste to penetrate, and then use a coating knife to remove the excess paste.
Once you have successfully filled all the holes and cracks, sand it lightly to reduce the inevitable application traces. Note that most coatings tend to shrink and dig in slightly; therefore, a new application is essential.
· Allows Application of a Smoothing Compound
The smoothing coating before the application of a painting eliminates small defects while aiming to level the surface. You can spread out the product with a wide-bladed knife, progressing in successive parallel bands that overlap very slightly. This wide knife used allows you to adjust the layer’s thickness. The greater the knife’s angle, the less plaster you leave and vice versa.
If the application is fairly regular, a second partial application of plaster can erase the last small defects.
However, if the surface is intended to receive a glossy glycerophtalic lacquer, the application of the smoothing coating must leave an irreproachable surface because the slightest defect will be visible.
For this, you can use a mirror to check the perfect flatness of the smoothing, just like the artisans. Place it on edge against the coated and sanded surface to mirror the reflected surface so that the slightest defect is obvious to you.
· Provides an Underlay
The undercoat is not necessary on old paint because the first application of diluted paint then acts as a primer. But if you are painting on a new wall, it is crucial to use surface preparation techniques to provide an underlay for the coating.
On the other hand, there are specific underlays for plasterboard with cardboard facing, cement, cellular concrete, and most absorbent substrates. In case you want expert advice, you can directly contact our support team at Attention to Detail Painters.
Looking For a Professional Contractor?
Look no further! Our company is locally owned and operated to ensure you receive premium quality services. We have experienced painters who can give your home in Littleton, CO, a new appealing look in no time. Need we say more? Click here to get professional painting assistance today!